66
BASIC TELEVISION CONNECTION

ANTENNA CONNECTION

· Connect the antenna or RF cable signal to the 75 ohm RF 'F' connector
socket located on the TV.
REMOTE STANDBY POWER
1 2 3
45 6
7 8 9
0
VOL CH
MENU OK
MUTE
AUTO
PICTURE
AUTO
SOUNDA/D
FORMATCLOCK SLEEP GUIDE
POWER
AV SAP
A/CH
CC INFO
FRONT PANEL STANDBY POWER
(EXAMPLE)

MAINS CONNECTION

· Ensure that the mains voltage and frequency are correct. Please refer
to the product labelling and documentation.
Note : The power button on the TV does not disconnect the television
from the AC mains. It toggles the TV between on and standby mode. To
completely turn off the AC mains power, you must unplug the AC mains
plugs from the wall socket.

SWITCHING ON THE SET

· Press the power button on the TV or on one of the optional remote
controls to switch the TV set on.
Note : If the TV is in commercial mode, it might not respond to the front
panel or the remote control. Please refer to the section on TV Installation
and TV Setup Menu in this documentation for more informaton.
USE & CARE OF OPTIONAL REMOTE CONTROLS
To load the supplied batteries into the remote control ;
- Remove the battery compartment lid from the back of the remote
control.
- Insert two AA-sized batteries into the battery compartment, making sure
the positive + and negative - polarity line up correctly as indicated
inside the case.
- Reattach the battery compartment lid.
Note : Always remove batteries from the remote control if it is not used for
a long period of time. This is to prevent damage to the remote control
due to battery leakage.
ITV_Nafta.indd 6 2006-10-05 5:41:21 PM