Setting the remote control to work accessory devices
Your TV remote control gives you the opportunity to control all your accessory devices with one single remote control. This can be done by selecting the correct brand and type out of the list of Direct Entry codes for accessory devices.
Press the SELECT button repeatedly to select DVD/R, CBL (SAT), VCR or AUX (CDR) according to the accessory device you want to operate with this remote control. See Use of the Remote control, p. 6.
If the function buttons on the remote control also work the selected accessory device, then the remote is ready and no further steps are needed.
If the function buttons do not work with the selected accessory device, according to the device(s) you own, you may make your remote control ready for them by a direct entry code. Proceed as following.
POWER
DVD/R CBL TV VCR AUX
| A/CH | SELECT | GUIDE |
| DEMO | CLOCK |
|
| MY CONTENT |
|
|
| = |
| INFO |
|
| ® |
|
SWIVEL | ® | OK | ® |
|
| ® |
|
| MENU |
| PIP |
+ +
VOL MUTECH/
PAGE
- -
_- ABCDEF
1 2 3
GHIJKLMNO
Code setup
&Press the SELECT button repeatedly to select your source according to the accessory device you want to operate with this remote control.
éPress the SELECT and POWER button at the same time for longer than 4 seconds. The selected mode LED will lit constantly.
“Input the digit code for the type and brand of accessory device. The codes are listed on page 40.
‘The selected mode LED will blink fast for 5 seconds as a confirmation you entered a correct code. The remote will go back to the last selected mode. If you entered a wrong code the mode LED will stay on for 2 seconds.
Redo step “.
(Now you will try to use the TV remote with the accessory device. Press the SELECT button repeatedly to select the desired mode.
The selected mode LED will stay on for 2 seconds and then begin blinking. The blinking means that the remote is in the accessory mode you have selected.
§Within 60 seconds from the time the blinking starts, point the remote toward the accessory device and press the POWER button. If the device does not respond to the POWER command, follow the steps for programming the remote again using a different setup code for the type and brand of accessory device you wish to operate. Refer again to the code list on page 40. If no more codes are listed for the type and brand of accessory device, the remote likely will not operate your particular model of accessory device.
Notes:
-Your TV remote is not necessarily capable of being programmed to operate all models of the brands of accessory devices listed on page 40.You may want to try the programming process again. Try using the number(s) that are listed for your type and brand of device to be sure you did not make a mistake in inputting the digits during your first attempt at programming.
-If the remote control is in one of the accessory modes (a mode light is flashing) — DVD/R, CBL,TV, VCR or AUX — and you don’t press any of the remote buttons for sixty seconds, a
To cancel the selected mode
Press the SELECT button for 2 seconds.
The remote control will return to TV mode.
39
