Philips 5616X manual To ReCharge, Charging base and will recharge continuously

Voltage

1

100-120V 220-240V

2

To (Re)Charge

4.

In North America, Central America and South America, the most common voltage is between 110V and 130V AC. Set Voltage Selector to 100- 120V setting. When traveling to other countries, common voltage may range to 240V AC. Set Voltage Selector to 220-240V setting. By setting Voltage Selector accordingly, razor may be charged on either 100 to 120 volt AC or 220 to 240 volt AC. Be sure to check the voltage setting located on the charging base. Slide switch to correct voltage setting before plugging base into outlet. (Fig. 1)

An adaptor plug may be necessary for cord usage in some foreign countries. It is suggested that you take all adaptor plugs with you when traveling over- seas to ensure compatibility with most foreign out- let configurations. Norelco Travel Adaptor Plug Kit, Model TP5, may be purchased at a store near you or at an Authorized Norelco Service Location.

1First time charging requires a full 8 hours. Green Charge Indicator Light may begin to blink before 8 hours has elapsed, however, continue charging razor for the full 8 hours. After the initial charge, the razor should be kept in the

charging base and will recharge continuously.

•Recharge at temperatures between 40º and 95º F. Charging at lower or higher temperatures adversely affects the life of the batteries.

•A fully charged razor will give approximately 36 minutes of shaving time.

2Press ON/OFF button OFF. Place razor in Charging Base and plug Base into outlet. The ON/OFF Button light will light.

3When razor is fully charged, the light will blink green (Fig. 2).

4Return razor to Charging Base after shaving.

5When the light starts blinking red, you need to recharge your razor. You will be able to complete the shave.