20ENGLISH
C 1 The light above faucet symbol will start blinking after each shave to remind you that the razor needs to be cleaned (except when the bottom light burns red).
Preparing Jet Clean System For Use
Important
◗Only use the razor,power plug,Jet Clean System and HQ200 cleaning solution provided to charge or clean razor.
◗Only use a Philips Norelco ‘XLCC’ model razor with the Jet Clean System.
◗Other Philips Norelco‘X’,‘XL’ or‘LC’ model razors DO NOT work with a Jet Clean System.
◗Empty the cleaning solution canister and thoroughly rinse the canister clean with warm water every 2 weeks.
◗The Jet Clean System thoroughly cleans but does not disinfect your razor, therefore, do not share razor with others.
◗Thecharging plug converts
◗Place the Jet Clean System on a flat, stable surface to avoid any leakage. Be careful not to tip or move the Jet Clean System if it is filled with the cleaning solution.
◗To avoid evaporation, do not expose cleaning solution to direct sunlight.
◗Remove the protective razor head cap from the razor before charging or cleaning the razor in the Jet Clean System.
ENGLISH 21
◗Use this appliance for its intended household use as described in this manual.
1Place the Jet Clean System on a flat,level surface.
C 2 Simultaneously press the buttons located on both sides of the Jet Clean System (1) and lift the appliance off the Jet Clean canister (2).
Always remove appliance from canister by lifting straight up. Do not tilt Jet Clean System.
3 Unscrew the lid on the Jet Clean Solution | |
| bottle (Model HQ200) provided with the |
| razor. Remove the airtight seal by lifting up |
| the tabs on the seal. Replace lid on the bottle |
| making sure the lid is screwed on securely. |
C 4 | Open lid and pour the Jet Clean Solution into |
| the canister up to the MAX indication |
| located inside the canister. |
NOTE: ONLY USE PHILIPS NORELCO JET | |
CLEAN SOLUTION (MODEL HQ200)WITH | |
THE JET CLEAN SYSTEM. ANY OTHER | |
SOLUTION MAY CAUSE DAMAGE TO YOUR | |
RAZOR. | |
