CAUTION: Abrasive cleaners or polishes will damage the surface finish.
Maintenance and Troubleshooting
The 718e climber requires very little maintenance. The only maintenance you need to do periodically is to clean the climber. You will also need to change the batteries when they wear down. Instructions for these procedures are provided in this section.
If you encounter problems with the climber, refer to Troubleshooting Tips in this section for help.
Cleaning the Climber
Clean the 718e climber periodically with mild solution of soap and water or a general household cleaner. Wipe the surface of the electronic console with a moist sponge or cloth. Dry with a clean towel. Never pour liquids on the 718e electronic console.
Changing the Batteries
The electronic console comes with two “AA” alkaline batteries installed. When your console no longer shows a digital readout or the count becomes erratic, you need to change the batteries.
Note: Occasionally, the batteries can become dislodged, so you need to reposition the batteries in the drawer, but not necessarily replace them with new batteries.
1.Find the drawer on the side of the electronic console and press in lightly to open it.
2.Use your fingers to slide the drawer out and expose the battery case. Remove the old batteries and replace them with two new “AA” alkaline batteries. The displays light up and the console beeps.
Note: Align the batteries to the proper polarity (+ and - indicators are inside the battery case).
3.Close the battery drawer by pushing it gently into the electronic console.
4.Press START/STOP to activate the timer (TIME display). Note: Press RESET to “reset” the displays to zero.
Page 26
