Diagram 16 |
Install the guide rope |
Pulley |
Finger guard |
Stair arm |
Right stair arm mount |
Guide rope |
c.Loop the rope over the pulley (through the finger guard on both sides of the pulley) and down into the left stair arm mount. See Diagram 16.
Diagram 17 |
Mark the guide rope |
Guide rope |
Pencil or pen mark |
Left stair arm mount |
CAUTION: Do not stand on the stair arms while performing these steps. Prior to working out, the tension on the guide rope must be set properly to avoid damaging the resistance cylinders and voiding the manufacturer’s limited warranty.
CAUTION: Check the knots and the length of the rope before standing on the stair arms. You cannot
d.Pull the rope taunt and mark the rope where it meets the stair arm mount. See Diagram 17.
Important: Before you mark the rope, be sure that the top of both stair arms line up with the top of the red box on the Precor label. Refer to Diagram 15 on page 13.
d.With the rope running through the stair arm mount, move both stair arms up so that you can easily tie a knot where you marked the rope. Note that if you placed the climber on its side to install the rope, return the climber to an upright position with the base flat on the floor.
e.Check the length of the guide rope by returning the stair arms to an even position shown in Diagram 15 on page 13. The top of both stair arms should line up with the red box located on the Precor label.
f.Step onto the stair arms. Test the stair stroke by moving your legs up and down a few times.
Page 14
