Diagram 10
Attach resistance cylinder to stair arm
Bolt
Washer
Resistance cylinder mount
Bushing
Nut
Stair arm
a.Align the resistance cylinder with the holes in the
b.Insert the bolt through the
c.Repeat step 6 to mount the other resistance cylinder.
Diagram 11
Install handrail
Bolt
Reed switch cable
Handrail console |
|
Handrail |
|
Upright support |
|
CAUTION: The reed switch | 7. Install Handrail. (Diagram 11) Take the two small bolts from the hardware |
cable should slide easily | kit. Position the handrail console (flat surface of the console should face |
through the upright support. | up) on top of the upright support and feed the reed switch cable through |
Do not tug on the cable | the large hole in the handrail console. Tape the connector to the top of the |
because you could void the | console. Align the bolt holes and secure the handrail console to the frame |
manufacturer’s limited | by inserting the bolts through the top of the handrail console and into the |
warranty. | upright support. Tighten the bolts firmly using the hex key (G). |
| Important: Pull gently on the excess cable as you feed the cable through |
| the large hole in the handrail console. If the cable does not move freely, |
| check to be sure that the cable is not pinched or crimped between the long |
| and short column mounts. See step 3. |
Page 11