Assembling the 718e Low Impact Climber
The information in this section provides instructions regarding the assembly of the 718e or 723e Low Impact Climber. You should carefully read and follow the instructions in this manual. If you do not assemble and use the climber according to the following guidelines, you could void the Precor limited warranty.
Installation Requirements
Follow these installation requirements when installing the climber:
•Set up the 718e climber on a solid, flat surface.
•Fill out and mail the limited warranty registration card. The serial number is located on the underside of the climber’s base. It is also located on a label on the outside of the box.
Assembly Instructions
To assist you in the assembly of the 718e climber, the items in the hardware kit, shown in Diagram 2, correspond to a particular letter in the alphabet. These letters appear throughout the assembly instructions. Refer to Diagram 2 while performing the steps below.
Note: You will need a scissors and a
Diagram 3 |
Place frame on base |
Upright support |
Stair arm |
Front crossbar |
Blocks or books |
Base |
1.Place Upright Support on Base. (Diagram 3) To install the upright support (long column that has the stair arms attached) take the following steps:
Important: Do not remove the red rope from the upright support. It is used to feed the reed switch cable through the upright support.
a.Place the base at or near the location where you will be using the climber. Lift the base onto wooden blocks or large hardcover books. This helps you access the underside of the base. Make sure that the rubber pads on the crossbar are facing the floor.
b.Position the upright support (long column) onto the base.
Note: Be sure to align the upright support and base properly. The front crossbar and upright support mounts are very close together as shown in Diagram 3.
Page 6
