Philips 8170XLCC manual Jet Cleaning the Razor

22ENGLISH

◗When the cleaning solution level drops below the minimum level, the cleaning light will blink with intervals and the razor holder will move to the starting position.

◗If you clean your razor every day, you should refill the canister approximately every 15 days.

C 5	Carefully lower the appliance back onto
	the Jet Clean canister making sure the
	release buttons snap back into place.

Jet Cleaning the Razor

◗If the razor does not contain enough power for one (1) shave, the Jet Clean Cleaning System may not work properly. Charge the razor in the Jet Clean System before using it to clean your razor.

◗The cleaning cycle takes approximately 1 hour to complete.

C 1	Connect the small plug to the Jet Clean
	System. Connect the charging plug into
	any 100V to 240V AC outlet. Use only the
	charging plug provided.
The razor holder automatically moves up to the
highest position.
2.	Place the Jet Clean System on a flat, level
	surface. Fill the cleaning canister with
	cleaning solution (see ‘Preparing Jet Clean
	System For Use’).

ENGLISH 23

C 3 Remove protective razor head cap from razor.

C 4	Place the razor head side down in the
	razor holder so that the razor head fits
	into the configuration shown inside the Jet
	Clean System. Gently press the base of the
	razor towards the back of the Jet Clean
	System so that the razor base fits snugly in
	place. Lock the razor into place by pushing
	the lever down completely.
The charging light will blink to indicate the razor
automatically begins to charge.
C 5	Press the ON/OFF button to start the
	cleaning cycle.
The cleaning light on the Jet Clean System starts
blinking and the razor is automatically lowered
into the cleaning solution.The razor stops
charging while it is cleaning.

◗During the first phase of the cleaning

cycle, the razor will automatically turn on and off several times while the razor holder lowers and raises the razor’s position in the cleaning solution, removing all debris. The cleaning light will blink continuously.

◗During the second phase of the cleaning cycle, the razor holder moves the razor to the drying position and the cleaning light will light up continuously.