FEATURE MENU CONTROLS (CONTINUED)
ADD/DELETE CHANNELS
channels it can find (on your Antenna or Cable TV system) into the TV's memory. Add/Delete Channels makes it easy for you to add other channels, or drop unwanted channels, from the list of channels in the TV's memory.
BEGIN
1Select CHANNEL MEMORY (ADD/DELETE CHANNELS) control.
With the FEATURES MENU on screen, move the RED highlight
with the MENU (M) 
buttons. Then press the MENU button.
2Press the CHANNEL ▲▼ or number buttons to select the channel you want to add or delete.
3Press the MENU ▶ button to ADD the channel into the TV's memory.
Press the MENU ◀ button to DELETE the channel from memory.
Repeat steps 2 and 3 for each channel you wish to add or delete.
4Press the STATUS or MENU button to clear the screen when through.
STOP
SMART HELP
Remember. You can also
add the AUX 1 VIDEO, AUX 2 VIDEO, AUX 1 Y PB PR, or SIDE VIDEO modes just like a channel. Then by pressing the CHANNEL ▲▼ buttons the AUX(iliary) mode can quickly be selected to use the desired set of Input jacks (see page 33).
Note: AUX(iliary) VIDEO modes are located between the lowest and highest channel numbers within the ADD/DELETE CHANNEL control screen.
MAIN MENU |
|
PICTURE | SOUND |
FEATURES | HELP |
1ST TIME SETUP | EXIT |
4
1 • | PLAY ▶ | STATUS |
| ||
CLEAR |
|
|
|
| |
REW |
| MENU |
|
| |
− | M | + | FF |
| |
◀◀ |
| ||||
|
|
|
| ▶▶ |
|
|
|
|
| PAUSE II |
|
MUTE | STOP | ■ | SURF | 3 | |
1 | VOL |
|
| CH |
|
ON/OFF | POS | SWAP | FREEZE | 2 | |
|
|
|
| SIZE |
|
2 TUNER PIP | 1 | 2 | 3 |
| |
A◀ ◀ B |
| ||||
TV/VCR 4 5 6
ENTER
SLEEP 7 8 9
SMART0
POWER VCR ACC TV
M O D E
FEATURE MENU |
|
PICTURE | CABLE |
SOURCE | TUNING |
CLOSED | CHANNEL |
CAPTIONS | MEMORY |
EXIT | MORE... |
| 1 OF 5 |
CHANNEL MEMORY |
|
ADD/DELETE |
|
CHANNELS |
|
START |
|
| |
EXIT | HELP |
ADD/DELETE CHANNEL
Channel 19 Added for ANT A
SELECT CHANNEL
to DELETE CHANNEL
A
B for ANT B 
M 
when FINISHED
NOTE: A separate ADD/DELETE CHANNEL memory may also be created for the ANT(enna) B Input on the rear of the set (if an Antenna or Cable TV signal has been connected). Just press the A◀ ◀ B button on the remote,
while in the ADD/DELETE CHANNEL mode, to switch between the ANT A and ANT B channel memory lists. Then follow steps 2 and 3 as shown to the left to add or delete the desired channels.
14
