Philips AC4118, AC4108 manual Before first use, Placing the zeolite gas filter, Using the appliance

English

Before first use

Placing the zeolite gas filter

The appliance comes with all filters, except the zeolite gas filter, fitted inside.

Tip: Place the appliance against a wall for more stability when you remove or insert filters. Note: Make sure you insert the filters in the correct position (with the arrow facing upwards).

Note:The appliance is equipped with a safety device. If you have not placed the ESP particle filter, the zeolite gas filter and the front panel properly, you cannot switch on the appliance.

1Place your fingers in the recesses of the side panels. (Fig. 2)

2Gently pull the top part of the front panel off the appliance (1) and then lift the panel upwards to remove it (2) (Fig. 3).

3To remove the ESP particle filter, grab the filter handles on both sides and gently slide the filter out of the appliance. (Fig. 4)

4Remove all packaging material from the zeolite gas filter and slide the filter into the appliance. (Fig. 5)

,You can only insert the zeolite gas filter after you have removed the particle filter.

5To insert the ESP particle filter, slide it into the appliance (‘click’) (Fig. 6).

6To reattach the front panel, insert the bottom edge first (1) and then press the top part home (2) (Fig. 7).

Using the appliance

AC4064/AC4054

1Put the plug in the wall socket

,The standby light goes on (Fig. 8).

2Press the function selection button one or more times to select the required function and setting (Fig. 9).

The corresponding light goes on and the standby light goes out.

,SmartAir Control: the built-in air sensor determines the ambient air quality and automatically selects the most appropriate speed. In the first few minutes after you select the SmartAir Control function, the air quality indicator flashes red to indicate that the air quality sensor is measuring the ambient air quality.After approximately 5 minutes, the air quality indicator lights up green if the air quality is good or lights up red if the air quality is poor (Fig. 10).

,BoostPower: the appliance operates at high speed for 30 minutes (BoostPower light is on) and then automatically switches to Smart Air Control (BoostPower light goes out

and SmartAir Control light goes on) (Fig. 11).

,Speed: the appliance operates at the speed you select.

-ê = low speed

-ë = medium speed

-í = high speed

3To stop the appliance from operating, press the function selection button until the standby light goes on (Fig. 12).

4Unplug the appliance.

Timer function

1Put the plug in the wall socket and select the required function and setting as described above.