POWER SUPPLY
Mains adaptor
1
Connect the mains adaptor to the set's DC 18Vsocket and to the power socket.
Helpful hints: To avoid damage to the set, use only the adaptor supplied!
The type plate is located on the bottom of the set.
Remote control
Important!
• Before using the remote control, remove the insulation plastic tab as
shown in the figure.
• If the remote control does not function correctly or the operating
range is reduced, replace the battery with a new (CR2025) type
battery.
1.
Pull the battery tray out as shown in the figure below.
2.
Replace a new battery according to polarity indication, and fully insert the
battery tray back to the original position.
Batteries contains chemical substances, so they should be disposed
of properly.
SELF-POWERED BACK-UP
The self-powered back-up conveniently allows your preset stations, alarm and clock
time settings to be stored for up to 10 minutes when there is a power interruption
e.g. AC power failure. The complete clock radio and backlight illumination will be
switched off.
•If power supply returns after 10 minutes and the display shows:
clock time blinking - indicates you need to re-adjust the clock time.
BASIC OPERATION
Switching on the system
•Press POWER.
™
The system will switch to the last selected source.
•Press TUNER/AUXor DOCK.
™
The system will switch to the selected source.
Switching the system to standby mode
•In any source mode, press POWER.
Switching off the volume temporarily
Press MUTEon the remote control to stop sound play-back instantly.
™
Playback will continue without sound and the display shows MUTE.
•To start sound playback you can:
– press MUTEagain;
– adjust the volume controls;
– change source.
Illumination brightness
Press REPEAT
ALARM /
BRIGHTNESSCONTROL once or more.
•
The brightness of the display can be adjusted:
Bright ➟Low ➟Off ➟Bright
.
SETTING THE CLOCK AND DATE
1. In any mode, press and hold TIMESET until clock digits flashes.
2.
Press
2;
to select 12 Hours/ 24 Hours mode.
2
3
1
CAUTION
High voltage! Do not open.You run the risk of getting an electric
shock. The machine does not contain any user-serviceable parts.
Modification of the product could result in hazardous radiation of
EMC or other unsafe operation.
This product complies with the radio interference requirements of
the European Community.
AJ301DB Eng 1/9/04 19:36 Page 4