INSTALLATION
POWER SUPPLY
1Check if the mains supply, as shown on the type plate located on the bottom of the set, corresponds to your local mains supply. If it does not,
consult your dealer or service centre.
2Connect the mains lead to the wall socket.
3To disconnect the set from the mains supply completely, remove the plug from the wall socket.
CLOCK MEMORY BACKUP
The clock memory backup allows your alarm and clock time settings to be stored for up to a day when there is a power interruption e.g. mains failure. The complete clock radio and display illumination will be switched off. As soon as the mains supply returns, the display will indicate the correct time.
1Remove the battery door to insert a 9 volt 6F22 type battery (not included) for
backup.
2Replace the battery door.
NOTE: If no backup battery is installed or the power interruption is prolonged, you will need to set the clock and alarm times again.
Batteries contain chemical substances so should be disposed of properly.
Standby power consumption . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3W
CAUTION
Use of controls or adjustments or performance of procedures other than herein may result in unsafe operation.
