Kenwood TM-V71A, TM-V71E instruction manual Installing the VGS-1Unit

Installing the VGS-1 Unit

Follow the instructions below to install the VGS-1 unit.

1 Remove the 8 screws from the cover of the base unit, then remove the cover itself from the unit.

2 From the 5 black cushions supplied with	cushion
the VGS-1, select the thickest rectangular
cushion (20 x 30 x 12 mm) and attach it to
the top surface of the VGS-1 unit.

• To prevent interferece to the terminal of the VGS-1, ensure that you attach the thick square cushion to the baseplate surface.

VGS-1

3 From the remaining cushions, select the	cushion
thickest square cushion (21 x 21 x 2.5
mm) and attach it to the printed circuit
board.

• The remaining cushions are not used with this transceiver.

• Ensure that the cushion is placed within the guidelines on the PCB.

guidelines

connector

4Insert the VGS-1 unit into the connector

on the transceiver.

• Press down on the top of the VGS-1 unit to ensure that it is securely attached to the connector.

5 Replace the cover on the base unit and secure it using the 8 screws.

93