Kenwood TM-V71A, TM-V71E instruction manual Preparation, Supplied Accessories, Mobile Installation

PREPARATION

Supplied Accessories

Note: A type code (K, E, or M4) can be found on the label attached to the package box.

	Item		Part Number	Quantity
Microphone			T91-0657-XX	1
DC power cable		K, M4 types	E30-7628-XX	1
(with 20 A fuses)		E type	E30-3452-XX	1
Mounting bracket			J29-0628-XX	1
Screw set			N99-0331-XX	1
Fuse (15 A)		K, M4 types	F51-0079-XX	1
		E type	F52-0024-XX	1
Warranty Card		K, E types only	——	1
Instruction manual			B62-1926-XX	1

MOBILE INSTALLATION

Select a safe, convenient location inside your vehicle that will minimize danger to your passengers and yourself while the vehicle is in motion. Consider installing the transceiver under the dash in front of the passenger seat so that knees or legs will not strike the radio during sudden braking of your vehicle. Try to a pick well-ventilated location that is shielded from direct sunlight.

Note: You may experience interference on your GPS receiver when using in or around 438.8 MHz (A band) and/or 443.8 MHz (B band). To eliminate the interference, ensure that the transceiver is installed at a location separate from your GPS receiver.

1Install the mounting bracket in the vehicle using the supplied self-tapping screws and flat washers (4 of each are supplied).

•The bracket can be mounted with the bracket opening facing down, for underdash mounting, or facing up.

•The bracket must be installed so that the 3 screw slots on the edge of each bracket side are facing the back.

Self-tapping screw

(5 x 16 mm) Flat washer