Kenwood TM-V71E, TM-V71A Replacing Fuses, Fuse Location Fuse Current Rating, Transceiver

3Connect the DC power cable to the transceiver.

• Press the connectors firmly together until the locking tab clicks.

Note: For your transceiver to fully exhibit its performance capabilities, we recommend using an optional PS-33 (20.5 A, 25% duty cycle) power supply.

Fuse holder (E type)

Black (—)

cable

Fuse holder

(K, M4 types)

Red (+)

cable Fuse holder (K, M4 types)

Regulated DC power supply

Fuse holder

(E type)

DC power cable

nReplacing Fuses

If the fuse blows, determine the cause, then correct the problem. After the problem is resolved, replace the fuse. If newly installed fuses continue to blow, disconnect the power cable and contact your authorized Kenwood dealer or an authorized Kenwood service center for assistance.

	Fuse Location	Fuse Current Rating
Transceiver		15 A
(located on the DC connector)
Supplied DC power cable		20A

Only use fuses of the specified type and rating; otherwise the transceiver could be damaged.

Fuse holder (E type)Fuse holder (K, M4 types)

Fuse	Fuse holder	Fuse
Fuse holder