Kenwood TM-V71A, TM-V71E instruction manual nInstalling the Panel Bracket

3 Connect the supplied sub-panel to the	sub-panel
operation panel.

• Install the sub-panel in a manner so as not to disrupt the cable.

4Connect the 8-pin connector of the supplied

modular cable to the base unit.

• The line filter is pre-installed onto the cable.

Approx. 3 cm line filter

nInstalling the Panel Bracket

1 Clean and dry the installation location.

Do not install the bracket close to an air bag.

2Remove the release paper from the base of the panel bracket, then secure it in place using the 3 supplied self-tapping screws.

•Allow the panel to set for a while, to ensure it remains fast. Otherwise, vibrations may occur.

•After removing the release paper, it cannot be reused.

3Attach the panel holder to the base bracket using the 2 supplied SEMS screws.

4Attach the operation panel to the panel holder so that it locks in place.

self-tapping screw

flat washer

panel bracket

Release paper

panel holder

SEMS screw

91