Kenwood TM-V71E, TM-V71A instruction manual Control Operation, Operation Dtmf Command

10 Press [REV] + Power ON to enter Remote Control mode.

•The and icons appear on the display.

•To exit Remote Control operation, turn the transceiver power OFF, then press [REV] + Power ON again.

CONTROL OPERATION

While in Remote Control mode, the DTMF keys of the handheld will function as shown in the table below. Each time you press the desired key, the handheld will automatically enter transmit mode and send the corresponding command to the mobile.

Operation	DTMF Command
Access your mobile via the remote unit (where *** is your	A *** #
3-digit secret number)
End access of your mobile via the remote unit	A #
DCS ON	1
Tone ON	2
CTCSS ON	3
DCS OFF (all signalling OFF)	4
Tone OFF (all signalling OFF)	5
CTCSS OFF (all signalling OFF)	6
Call mode ON	7
VFO mode ON	8
Memory mode ON	9
Transmit power (press to toggle between High, Medium, and	0
Low)
Frequency (in VFO mode) or Memory channel (in Memory	A XXXXXXX
mode) directy entry
DCS code (when DCS is ON), Tone frequency (when Tone is	B XXX
ON), or CTCSS frequency (when CTCSS is ON) setup
Repeater (Cross-band or Locked-band) ON	C
Repeater OFF	D
Step the frequency or Memory channel down
Step the frequency or Memory channel up	#

86