Kenwood TM-V71A, TM-V71E Using Program Scan, To quit Program Scan, press VFO again

8Press [F].

9Rotate the Tuning control to select a matching channel number from U0 to U9.

•For example, if you selecte channel L3 in step 5, select channel U3 here.

10Press [MR] to set the channel number.

•The upper limit is stored in the channel.

•To confirm the stored scan limits, press [MR], then select the L and U channels.

Note:

uThe lower limit must be lower in frequency than the upper limit.

uThe lower and upper frequency step sizes must be equal.

uThe lower and upper limits must be selected on the same band.

nUsing Program Scan

1 Select your desired band.

2 Press [VFO].

3 Rotate the Tuning control to select a frequency within your desired scan range.

4 Press [VFO] (1s).

•Scan starts at the current frequency.

•The 1 MHz decimal blinks while scanning is in progress.

•To reverse the scan direction, turn the Tuning control clockwise (upward scan) or counterclockwise (downward scan). You can also press microphone [UP]/ [DWN].

5To quit Program Scan, press [VFO] again.

Note:

uIf the step size differs between the lower limit and upper limit, VFO scan will begin instead of Program Scan.

uIf the current VFO frequency is within more than one Program Scan range, the range stored in the smallest channel number is used.

47