Kenwood TM-V71E, TM-V71A instruction manual DCS Code ID, Press F, Tone 1s

DCS Code ID

This function scans through all DCS codes to identify the incoming DCS code on a received signal. You may find it useful when you cannot recall the DCS code that the other persons in your group are using.

1Press [TONE] 3 times to activate the DCS function.

•The icon appears on the display when the DCS function is ON.

•Each press of [TONE] changes the selection as follows: Tone (T) –> CTCSS (CT) –> DCS (DCS) –> Off (no display).

2Press [F], [TONE] (1s).

•The icon blinks and “SCAN” appears on the display.

•Scan starts when a signal is received.

•To reverse the scan direction, turn the Tuning control clockwise (upward scan) or counterclockwise (downward scan). You can also press microphone [UP]/ [DWN].

•To quit the scan, press [F] (ESC).

•When a DCS code is identified, the identified code appears on the display and blinks.

3Press the Tuning control to program the identified code in place of the currently set DCS code.

•The DCS function will remain ON. To cancel DCS, press [TONE] until DCS no longer appears on the display.

•Press [F] (ESC) if you do not want to program the identified code.

•Rotate the Tuning control while an identified code is blinking, to resume scanning.

54