Kenwood TM-V71E Character Entry, Rotate the Tuning control to select your desired character

Character Entry

Certain menus require you to enter characters, such as the power on message and memory names. When character entry is required, a cursor will appear on the display.

1Press the Tuning control.

•The cursor will blink.

2Rotate the Tuning control to select your desired character.

•You can enter characters as described below:

-Power on message, memory name, and repeater ID (K type only): 0 ~ 9, A ~ Z, -, /, @, and space

-DTMF memory code: 0 ~ 9, A ~ F, and space

-EchoLink memory code: 0 ~ 9, A ~ F

-Memory group link and wireless remote ID (K type only): 0 ~ 9

3Press the Tuning control to set the selected character.

•The cursor will move to the next digit.

•You can move the cursor to the left or right by pressing [REV] () or [LOW] ().

•You can delete the selected character by pressing [PF1] (CLR).

4Repeat steps 2 and 3 to enter the remaining characters.

•Press [F] (ESC) at any time to exit Menu mode.

•Press [TONE] (BACK) at any time to cancel the Menu setup and return to the Menu selection.

24