Kenwood TM-V71A Storing Simplex and Standard Repeater Frequencies, Call Channel Memory Simplex

Storing Simplex and Standard Repeater Frequencies

1Press [VFO] to enter VFO mode.

2Rotate the Tuning control to select your desired frequency.

•Additionally, you can press the microphone [UP]/[DWN] keys to select a frequency.

3Set up any additional data desired for the frequency.

•Offset direction, Tone ON/OFF, Tone frequency, CTCSS ON/OFF, CTCSS frequency, DCS ON/OFF, DCS code, etc.

4Press [F].

•A memory channel number appears.

5Rotate the Tuning control to select your desired channel number.

•Additionally, you can press the microphone [UP]/[DWN] keys to select a channel.

6Press [MR] to store the data in the selected Memory channel.

Note: If you store the data in a Memory channel that already has data stored in it, the old data will be cleared and the new data will be stored.

nCall Channel Memory (Simplex)

The Call channel can be used to store any frequency and related data that you will recall often. You may want to dedicate the Call channel as an emergency channel within your group.

To store a simplex frequency and related data as the Call channel instead of in a Memory channel, after step 4 (above), press [CALL].

Note: Storing new data in the Call channel will clear the old data. (The Call channel itself cannot be cleared, but data can be replaced with new data.)

Storing Odd-Split Repeater Frequencies

Some repeaters use a receive and transmit frequency pair with a non-standard offset. To access those repeaters, store two separate frequencies in a memory channel. You can then operate on those repeaters without changing the offset frequency you stored in the menu.

1Set up a simplex channel by following steps 1 to 6 of “STORING SIMPLEX AND STANDARD REPEATER FREQUENCIES”, above.

2Press [VFO] to enter VFO mode.

3Rotate the Tuning control to select your desired transmit frequency.

• Additionally, you can press the microphone [UP]/[DWN] keys to select a frequency.

33