Philips AJ3540s user service Switching Off The Alarm

SWITCHING OFF THE ALARM

There are three ways of switching off the alarm. Unless you cancel the alarm completely, the 24 hour alarm reset option will be automatically selected after 59 minutes, from the time your alarm time first goes off.

24 HOUR ALARM RESET

If you want the alarm mode to be stopped immediately but also wish to retain the same alarm setting for the following day:

• Press SET TIME/ALARM OFF during the alarm call.

CANCELING THE ALARM COMPLETELY

To cancel the set alarm time before it goes off, or during the alarm call:

•Adjust OFF/ON/AUTO/BUZZ to OFF position.

REPEAT ALARM

This repeats your alarm call at 7-8-minute intervals.

1During the alarm call, press REPEAT ALARM.

2Repeat if desired for up to 59 minutes.

SLEEP

This set has a built-in timer which enables the set to be automatically switched off during radio playback after a set period of time. This allows you to lie back, listen and fall asleep. The maximum sleep time is 59 minutes.

Setting SLEEP

1Set OFF/ON/AUTO/BUZZ to OFF position.

2Set your sleep time by pressing on the SLEEP button. Keep your finger on the button and the display will begin to count down from 0:59 to 0:00 minute.

™To cancel sleep, press SET TIME/ALARM OFF.

™To view the remaining sleep time, press SLEEP.

TROUBLESHOOTING

If a fault occurs, first check the points listed below before taking the set for repair.

If you are unable to remedy a problem by following these hints, consult your dealer or service center.

WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty. Do not open the set as there is a risk of electric shock.

Problem

–Possible Cause

• Remedy

No sound/power

–Volume not adjusted

• Adjust the volume

Occasional crackling sound during FM broadcast

–Weak signal

• Adjust the position of the power cord

Continuous crackling/hiss disturbance during MW broadcast

–Electrical interference from TV, computer, fluorescent lamp, etc.

• Move set away from other electrical equipment

The alarm does not function

–Alarm time not set and or alarm mode not selected

• Set the alarm time and / select alarm mode

–Volume too low for RADIO

• Adjust the volume

–Radio alarm not adjusted to radio station

• Tune to a radio station

SAFETY INFORMATION

•Place the set on a hard and flat surface so that the system does not tilt.

•If you do not intend to use the set for a long time, withdraw the power plug from the wall outlet. In addition to this, it is advisable to remove the battery from the clock radio. This will prevent any danger of leakage and the clock radio will not be damaged.

•Do not expose the set, batteries to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight.

•The apparatus shall not be exposed to dripping or splashing.

•Adequate ventilation with a minimum gap of 15cm between the ventilation holes and surrounding surfaces is necessary to prevent heat build-up.

•The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, table-cloths, curtains, etc..

•No objects filled with liquids, such as vases, shall be placed on the appartus.

•No naked flame sources, such as lighted candles, should be placed on the apparatus.

•To clean the set, use a soft, slightly dampened chamois leather. Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the housing.

CAUTION

Use of controls or adjustments or performance of procedures other than herein may result in unsafe operation.

The set complies with the FCC-Rules, Part 15.

Operation is subject to the following two conditions:

1.This device may not cause harmful interference, and

2.This device must accept any interference received, including interference that may cause undesired operation.