Scan Play (Intro Music Scan)
Press the SCN button 8, then the display shows “SCN”, then the CD will play the first 10 seconds of each track of the whole disc. Press the SCN button 8 again to disengage the unit from scan play.
*A scan play will start from the track following the one currently playing.
Repeat Play
Press the RPT button 7, then the display shows “RPT”, then the track currently playing will be played repeatedly. Press the RPT button 7 again to disengage the unit from repeat play.
Random Play
Press the RDM button 6, then the display will show “RDM”, then the entire tracks on the disc will be played at random. Press the RDM button
6again to disengage the unit from random play.
English
9. TROUBLESHOOTING
| Problem | Cause | Measure | ||
|
|
|
|
| |
| Power does not | Fuse is blown. | Replace with a fuse of the same amperage. If the | ||
| turn on. |
| fuse blows again, consult your store of purchase. | ||
| (No sound is |
|
|
| |
|
| Consult your store of purchase. | |||
| produced.) | Incorrect wiring. | |||
|
|
|
| ||
| No sound output | Power antenna lead is | 1. Turn the unit off. | ||
| when operating | shorted to ground or | 2. Remove all wires attached to the power antenna | ||
| the unit with | excessive current is required | lead. Check each wire for a possible short to | ||
| amplifiers or | for | ground using an ohm meter. | ||
| power antenna | or power antenna. | 3. Turn the unit back on. | ||
| attached. |
| 4. Reconnect each amplifier remote wire to the | ||
|
|
| power antenna lead one by one. If the amplifiers | ||
|
|
| turn off before all wires are attached, use an | ||
General |
|
| external relay to provide | ||
|
| (excessive current required). | |||
|
|
| |||
|
|
|
| ||
| Nothing happens | The microprocessor has | Turn off the power, then press the Open button 1 | ||
| when buttons are | malfunctioned due to noise, | and remove the DCP. | ||
| pressed. | etc. | Press the reset button for about 2 seconds with a | ||
| Display is not |
| thin rod. | ||
|
|
|
| ||
| accurate. |
|
|
| |
|
|
|
| Reset button | |
|
|
|
| ||
|
|
|
| ||
|
|
|
| ||
|
| DCP or main unit connectors | Wipe the dirt off with a soft cloth moistened with | ||
|
| are dirty. | cleaning alcohol. | ||
| Compact disc | Another compact disc is | Eject the compact disc before loading the new one. | ||
| cannot be | already loaded. |
|
| |
| loaded. |
|
|
| |
|
|
|
| ||
| Sound skips or is | Compact disc is dirty. | Clean the compact disc with a soft cloth. | ||
CD | noisy. |
|
|
| |
Compact disc is heavily | Replace with a compact disc with no scratches. | ||||
| |||||
|
| scratched or warped. |
|
| |
|
|
|
| ||
| Sound is bad | Water droplets may form on | Let dry for about 1 hour with the power on. | ||
| directly after | the internal lens when the |
|
| |
| power is turned | car is parked in a humid |
|
| |
| on. | place. |
|
| |
|
|
|
|
|
14 BD416