Clock | Radio |
Setting the clock
The clock uses
1Press and hold MODE until clock digit for
hour flashes.
2Hold down ∞ / § to adjust the hours.
3 Press MODE to confirm the hour setting.
➜The clock digits for minute flash.
4Hold down ∞ / § to adjust the minutes.
5 Press MODE to confirm the setting.
Standby power consumption
(clock mode) . . . . . . . . . . . . . . . . . . . .. . . . 2.4W
Radio
Tuning to radio station
1Press
2Press repeatedly SOURCE to select FM or MW.
➜The radio station frequency, waveband will be displayed briefly, then clock is displayed. 
is also displayed. (See 2 )
3Press and hold ∞ or § until the frequency in the display starts running.
➜The radio automatically tunes to a station of sufficient reception.
4Repeat step 2 if necessary until you find the desired station.
•To tune to a weak station, press ∞ or § briefly and repeatedly until you have found optimal reception.
Programming radio stations
You can store 20 FM and 10 MW radio stations in the memory manually or automatically.
Autostore
Autostore automatically starts programming radio stations from preset 1. Any previous presets e.g. manually programmed will be erased.
1Press repeatedly SOURCE to select FM or MW.
2Press and hold PROG until the frequency in the display starts running.
➜Available stations are programmed (MW or FM).
To listen to a preset or autostore station
Press the PRESET +/– once or more until the desired preset station is displayed.
Manual programming
1Tune to your desired station (see Tuning to radio stations).
2Press PROG to activate programming. ➜ Display: P01 flashes.
3Press PRESET +/- once or more to allocate a number (FM: from 1 to 20; MW: from 1 to 10).
4Press PROG to confirm.
5Repeat steps
Helpful hints:
–You can erase a preset station by storing another frequency in its place.
To improve reception:
FM: Extend and adjust the pigtail for optimum reception.
MW: Uses a
This set complies with the radio interference requirements of the European Community.
