Power Supply | General Operation/Tuner |
Using AC power
WARNING: Always check you have completely switched off the set, before you change or disconnect power supply.
1Check if the power voltage, as shown on the type plate located on the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or service center.
2Connect the power cord to the AC MAINS~ inlet and the wall socket.The set is now connected and ready for use.
3To switch the set off completely, withdraw the power cord from the wall socket.
4Install the unit near the AC outlet and where the AC power plug can be easily reached.
•Disconnect the power cord from the wall socket to protect your set during heavy thun- derstorms. Children could seriously injure themselves as the free end of the cable may still be live if only the connector is removed from the MAINS socket at the back of the unit.
The type plate is located on the bottom of the set.
Helpful hints:
–To avoid unnecessary energy consumption, always adjust the Source selector to OFF after using the set.
General operation
Switching on and off and selecting the function
1To select your sound source, adjust the Source selector to: CD, FM or MW.
2To switch off the set, adjust the Source selector to OFF position
Adjusting volume
Adjust the sound with the VOLUME con- trols.
Radio reception
1Adjust the Source selector to FM or MW to select your desired waveband.
2Turn TUNING to tune to a station.
Helpful hints:
To improve radio reception
•For FM, extend, incline and turn the telescop- ic antenna for best reception. Reduce its length if the signal is too strong.
•For MW, the set uses a
