Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING: Do not open the set as there is a risk of electric shock. Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee.
Problem
–Possible cause
• Remedy
No sound /power
–Volume not adjusted
• Adjust the VOL
–Power cord not securely connected
•Connect the AC power cord properly
– Batteries dead/ incorrectly inserted
•Insert (fresh) batteries correctly
–Headphones connected to the set
• Disconnect headphones.
–CD contains
•Press ∞ , § once or more to skip to a CD audio track, instead of the data file.
Display does not function properly / No
reaction to operation of any of the
Poor radio reception
–Weak radio signal
•FM: Adjust the FM telescopic aerial--indication
–No CD inserted
• Insert a CD
–CD badly scratched or dirty
•Replace/ clean CD, see Maintenance
– Laser lens steamed up
•Wait until lens has cleared
–
•Use a finalized
Note:
Make sure the CD is not encoded with Copyright protection technologies, as some do not conform to the Compact Disc stan- dard.
controls
–Electrostatic discharge
•Switch off and unplug the set. Reconnect after a few seconds´´
Severe radio hum or noise
–Electrical interference: set too close to TV, VCR or computer
•Increase the distanceThe CD skips tracks
–CD damaged or dirty
• Replace or clean CD
–Program/Shuffle is active
• Quit program/shuffle mode
Note: A CD badly scratch or dirty may result in improper operation.
Environmental information
All unnecessary packaging material has been omitted.The packaging can be easily separated into three materials: cardboard, polystyrene and plastic.
Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging, dead batteries and old equipment.