Philips AZ1123WCD Maintenance & safety See, CD player and CD handling, Safety information

Maintenance & safety (See 7)

CD player and CD handling

•If the CD player cannot read CDs correctly, use a cleaning CD to clean the lens before taking the set to repair.

•The lens of the CD player should never be touched!

•Sudden changes in the surrounding temperature can cause condensation on the lens of your CD player. Playing a CD is then not possible. Do not attempt to clean the lens but leave the set in a warm environment until the moisture evaporates.

•Always close the CD-tape door to avoid dust on the lens.

•To clean the CD, wipe in a straight line from the center towards the edge using a soft, lint-free cloth. Do not use cleaning agents as they may damage the disc.

•Never write on a CD or attach any stickers to it.

Safety information

•Place the set on a flat, hard and stable surface so that the system does not tilt.

•Where the MAINS plug or an appliance cou- pler is used as the disconnect device, the dis- connet device shall remain readily operable.

•Do not expose the set, batteries, CDs to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight.

•The apparatus shall not be exposed to drip- ping or splashing.

•Adequate ventilation with a minimum gap of 15cm (6 inches) between the ventilation holes and surrounding surfaces is necessary to prevent heat build-up.

•Do not cover the ventilation openings with items such as newspapers, table-cloths, cur- tains, etc.

•No objects filled with liquids, such as vases, shall be placed on the apparatus.

•No naked flame sources, such as lighted can- dles, should be placed on the apparatus.

•The mechanical parts of the set contain self-lubricating bearings and must not be oiled or lubricated.

•To clean the set, use a dry cloth. Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the housing.

Disposal of your old product

Your product is designed and manufactured with high quality materials and components, which can be recycled and reused.

When this crossed-out wheeled bin symbol is attached to a product it means the product is covered by the European Directive 2002/96/EC.

Please inform yourself about the local separate collection system for electrical and electronic products.

Please act according to your local rules and do not dispose of your old products with your normal household waste.The correct disposal of your old product will help prevent potential negative consequences for the environment and human health.