Philips AZ1148 manual Digital Tuner, Tuning To Radio Stations, To improve radio reception, English

DIGITAL TUNER

TUNING TO RADIO STATIONS

1.	Select TUNER source.
™	is displayed briefly and then the radio station
	frequency is shown.	CD
2.		PROGRAM
	Press BAND once or more to select your waveband.	REPEAT
		ALL
3.	Press ∞ or § on the set or on the remote control and release
	when the frequency in the display starts running.

™The tuner automatically tunes to a station of sufficient

reception. Display shows during automatic tuning.

™If a FM station is received in stereo, STEREO is shown.

4.Repeat step 3 if necessary until you find the desired station.

• To tune to a weak station, press ∞ or § briefly and

repeatedly until you have found optimal reception.

5.Adjust the power slider to TAPE/OFF position to switch off the set.

To improve radio reception

–For FM, pull out the telescopic aerial. Incline and turn the aerial. Reduce its length if the signal is too strong (very close to a transmitter).

–For MW/LW, the set is provided with a built-in aerial so the telescopic aerial is not needed. Direct the aerial by turning the whole set.

Favourite station selection

For your favourite 3 tuner stations, you can use the easy one-touch programming and selection 1, 2 or 3 buttons.

1.	Tune to your desired station (see Tuning to radio stations).	ALL
		CD
		OGRAM
		EPEAT
2.	To store your station, press 1, 2 or 3 for 2 seconds or more.
™ Display: shows PROGRAM briefly, your favourite preset station
	number and the tuner frequency.

Programming radio stations

You can store up to a total of 30 radio stations in the memory.

1.Tune to your desired station (see Tuning to radio stations).

2.Press PROGRAM to activate programming.

– Display: PROGRAM flashes.

3.Press PRESET 4 or 3 once or more to allocate a number from 1 to 30 to this station.

4.Press PROGRAM again to confirm the setting.

– Display: PROGRAM disappears, the preset number and the frequency of the preset station are shown.

5.Repeat the above four steps to store other stations.

–You can overwrite a preset station by storing another frequency in its place.

Tuning to preset stations

Press 1, 2, 3 or PRESET 4 or 3 until the desired preset station is displayed.

		PRESET	BAND
1	2	3

REMOTE

SENSOR

SEARCH

PROGRAM

FM

TUNER

STEREO

		PRESET	BAND
1	2	3

REMOTE

SENSOR

SEARCH

PROGRAM

		PRESET	BAND
1	2	3

REMOTE

SENSOR

SEARCH

PROGRAM

English

7