MP3-CD/ CD Player
2Press CD/USB to enter CD mode if USB is displayed.
➜Display will show
3Open the disc door.
4Insert a disc with the printed side facing up and press the disc door gently to close.
➜Display:The total number of tracks appears.
➜The disc scanning of
5Press 2; to start playback.
➜Display: 2 and the current track number.
For MP3-CD/ WMA only:
➜The current track number “XXX“ and album number “ALB XXX“ will be displayed interchangeably (See 4 5).
6To pause playback press 2;.
➜ Display: 2 and the current track number flash.
7Press 2; again to resume playback.
8To stop playback, press 9.
Helpful hints:
The disc playback will also stop when:
–you open the disc compartment door;
–you select FM, MW or OFF position;
–the disc has reached the end of the playback.
Selecting a different track
•Press ∞ or § once or repeatedly until the desired track number appears in the display.
For
•In the pause/stop position, press 2; to start playback.
Finding a passage within a track
1During playback, press and hold down ∞ or §.
➜The disc is played at high speed and low volume.
2When you recognize the passage you want, release ∞ or §.
➜ Normal playback resumes.
Programming tracks
You may store up to 20 tracks in the desired sequence. If you like, store any track more than once.
1In the stop position, press PROG to start programming.
➜Display shows P01 indicating the start of
the program. PROG flashes. (See 6)
2Press ∞ or § to select your desired track number.
For
3Press PROG to store the desired track.
➜Display shows P02, indicating the next program location available.
4Repeat steps 2 to 3 to select and store all desired tracks.
5Press 2; to play the program.
To review your program
In the stop position, press and hold PROG 3 seconds.
➜The display shows all the stored tracks in sequence.
Helpful hints:
–Display shows P01 if no track is programmed.
–If you try to store more than 20 tracks, no track can be stored and the display will show
FUL.
