Philips AZ 1018 Troubleshooting, Problem, Solution, No sound, No power, Display does not function

English

Troubleshooting

If a fault occurs, first check the points listed below before taking the set for repair. Do not open the set as there is a risk of electric shock.

If you are unable to remedy a problem by following these hints, consult your dealer or service center.

WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty.

Problem	Solution
No sound	– Adjust the VOLUME
No power	– Power cord not securely connected. Connect AC
	power cord properly
	– Batteries dead /incorrectly inserted. Insert (fresh)
	batteries correctly
Display does not function	– Electrostatic discharge
properly/ No reaction to	Switch off and unplug the set. Reconnect after a few
operation of any of the	seconds.
controls
no d1SC, Cd Err or	– No CD inserted, insert a CD
nF d1SC indication	– CD badly scratched/ dirty. Replace/ clean CD (see
	maintenance)
	– CD-(R) is blank or the disc is not finalized.
	Use a finalized CD-R(W)
	– Laser lens steamed up. Wait until lens has acclimatized
Laser lens steamed up	– Wait until lens has cleared
	– Wait until lens has acclimatized
CD playback does not work	– CD badly scratched/ dirty. Replace/ clean CD (see
	maintenance)
The CD skips tracks	– CD damaged or dirty. Replace or clean CD.
	– Program is active. Quit program mode
Poor cassette sound quality	– Dust and dirt on the heads, etc.
	Clean deck parts, see maintenance.
	– Use of incompatible cassette types (METAL or
	CHROME). Only use NORMAL (IEC I) for recording
Recording does not work	– Cassette tab(s) may be broken. Apply a piece of
	adhesive tape over the missing tab space.

16