Philips AZ 1018 manual Radio reception

English	Radio
	Radio reception	stations in the memory.
		Programming radio stations
	AZ1018	You can store up to a total of 30 radio
		AZ
	VOLUME
	BATT
	LOW
	PLAY-	VOLUME
	PAUSE
	STOP
	CDMODE	BATT
	PROGRAM	LOW
		PLAY-
	FM•AM	PAUSE
	SE	STOP
	AR
	CH
	PRESET	CDMODE
		PROGRAM
		FM•AM
		SE
		AR
		CH
		PRESET
	1 Adjust the POWER slider to RADIO.
	➜ Display: shows tu briefly.The radio
	frequency is then shown.	1 Tune to your desired station (see Radio
	2 Press FM•AM once or more to select the	Reception).

desired waveband.	2 Press CD MODE/ PROGRAM to
➜ Display: shows your waveband	activate programming.
3 Press and hold down SEARCH ∞ or §	➜ Display: PROGRAM flashes.
	3 Press PRESET 3 or 4 once or more to
briefly to tune to a radio station. Release
when the frequency in the display starts to	allocate a number from 1 to 30 to this
change.	station.
➜ The radio automatically tunes to a radio	4 Press CD MODE/ PROGRAM again to
station of sufficient reception. Display
	confirm the setting.
shows Srch during automatic tuning.
	➜ Display: PROGRAM disappears, the preset
• To tune to a weak station, press SEARCH	number and the frequency of the preset
∞ or § briefly and repeatedly until you	station are shown.
have found optimal reception.	5 Repeat the above four steps to store other
To improve reception
	stations.
– For FM, pull out the telescopic antenna.	• You can erase a preset station by storing
Incline and turn the antenna. Reduce its length
	another frequency in its place.
if the signal is too strong (very close to a
transmitter).	Tuning to preset stations
– For AM the set is provided with a built-in	Press PRESET 3 or 4 until the desired
	preset station is shown.
antenna so the telescopic antenna is not
needed. Direct the antenna by turning the
whole set.

4To switch off the radio, adjust the POWER slider to TAPE/OFF position and check the cassette keys are released.

10