Red Reset Button
A red button, near the power switch, resets the treadmill’s circuit breaker. If the running belt stops unexpectedly and all display console functions cease, the circuit breaker may have been tripped.
To reset the system, take the following steps:
1.Use the power switch beneath the front panel to turn the treadmill Off.
2.Make sure the treadmill is located away from heating ducts. If necessary, move the treadmill to an appropriate location. Refer to Location.
3.Wait a few minutes. Make sure the magnetic safety key is properly positioned on the display console.
4.Push the red reset button, and then turn the treadmill On.
5.Check the display to verify that the Precor banner is scrolling across the display. If the display remains blank, call Precor customer support. Refer to Obtaining Service.
Troubleshooting Error Codes
Initially, when the unit is turned On, the display lights all the LEDs. If any are dark, call an authorized service person for assistance.
The following table shows the error codes that may appear in the display. If you see these error codes, call an authorized service person for assistance because the treadmill needs to be recalibrated. Refer to Obtaining Service.
Code | Description |
|
|
E3 | EEPROM error. |
|
|
E26 | Speed signal is not being received. |
|
|
E40 | A problem occurred with the lift. |
|
|
Owner’s Manual: Advanced Programming and Troubleshooting | 39 |
