POWER SUPPLY

Whenever convenient, use the power supply if you want to conserve battery life. Make sure you remove the plug from the set and wall outlet before inserting batteries.

BATTERIES (NOT INCLUDED)

1. Open the battery compartment and insert six batteries, type R-20, UM-1or D-cells, (preferably alkaline) with the correct polarity as indicated by the "+" and "-" symbols inside the compartment.

6 x R20 • UM-1 • D-CELLS

2.Replace the compartment door, making sure the batteries are firmly and correctly in place. The set is now ready to operate.

–If BATT LOW lights up, battery power is running low.

–The BATT LOW indicator eventually goes out if the batteries are too weak.

Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst. Therefore:

•Do not mix battery types: e.g. alkaline with carbon zinc. Only use batteries of the same type for the set.

•When inserting new batteries, do not try to mix old batteries with the new ones.

•Remove the batteries if the set is not to be used for a long time.

Batteries contain chemical substances, so they should be disposed of properly.

Using AC POWER

1. Check if the power voltage as shown on the type plate on

the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or service center.

2. If your set is equipped with a voltage selector, adjust the selector so to match with the local power supply.

3. Connect the power cord to the wall outlet and the set is now ready for use.

4.To disconnect the set from the power supply completely, remove the plug from the wall outlet.

English

9