POWER SUPPLY | DIGITAL TUNER |
IMPORTANT!
•Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst.
•Do not mix battery types: e.g. alkaline with carbon zinc. Only use batteries of the same type for the set.
•When inserting new batteries, do not try to mix old batteries with the new ones.
•Batteries contain chemical substances, so they should be disposed of properly.
Using AC Power
1.Check if the AC power supply, as shown on the type plate located on the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or service center.
2.Connect the power cord to the wall outlet.
3.To disconnect the power supply, unplug the set from the wall outlet.
The type plate is located on the bottom of the set.
DIGITAL TUNER
Tuning to radio stations
1.Adjust the POWER slider to RADIO.
ªtu is displayed briefly and then the radio station frequency, waveband and, if pro- grammed, a preset number are shown. (See 3)
2.Press BAND once or more to select your wave- band.
3.Press and hold SEARCH ° or ¤ until the frequency in the display starts running.
ªThe radio automatically tunes to a station of sufficient reception. Display shows Srch during automatic tuning.
4.Repeat step 3 if necessary until you find the desired station.
To tune to a weak station, press ° or ¤ briefly and repeatedly until you have found optimal reception.
To improve radio reception:
•For FM, extend, incline and turn the telescopic antenna. Reduce its length if the signal is too strong.
•For AM, the set uses a
BASIC FUNCTIONS
Switching on and off and selecting function
1.To switch on, adjust the POWER slider to select: CD, RADIO or TAPE function, and operate the respective function controls.
2.To switch off, adjust the POWER slider to select TAPE/OFF and make sure all the
cassette keys are released.
Note : The DBB setting, tuner presets and the volume will be retained in the set's memory.
Adjusting volume and sound (See 2)
1.Press the VOLUME 3 or 4 controls to adjust the volume.
2.Press DBB once or more to select dynamic bass boost on or off.
Programming radio stations
You can store up to a total of 40 radio stations in the memory, manually or automatically (Autostore).
Manual programming
1.Tune to your desired station (see Tuning to radio stations).
2.Press PROGRAM to activate programming. ª Display: Pr
3.Use the digit panel on the set to key in a number,
4)
•Remote control (AZ1505 models only): Press PRESET + / - once or more to select a preset station.
4.Press PROGRAM to confirm.
5.Repeat steps