immediately. Contact Philips Consumer Care to have the product checked before use.
•Never place the product and accessories near naked flames or other heat sources, including direct sunlight.
•Never insert objects into the ventilation slots or other openings on the product.
•Where the mains plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable.
•Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like.
•Disconnect the product from the power outlet before lightning storms.
•When you disconnect the power cord,
always pull the plug, never the cable. Risk of short circuit or fire!
•Before you connect the product to the power outlet, ensure that the power voltage matches the value printed on the back or bottom of the product. Never
connect the product to the power outlet if the voltage is different.
Risk of injury or damage to the product!
•Visible and invisible laser radiation when open. Avoid exposure to beam.
•Do not touch the disc optical lens inside the disc compartment.
•Never place the product or any objects on power cords or on other electrical equipment.
•If the product is transported in temperatures below 5°C, unpack the product and wait until its temperature matches room temperature before connecting it to the power outlet.
Risk of overheating!
•Never install this product in a confined space. Always leave a space of at least four inches around the product for ventilation.
Make sure that curtains or other objects
never cover the ventilation slots on the product.
Risk of contamination!
•Do not mix batteries (old and new or carbon and alkaline, etc.).
•Remove batteries if they are exhausted or if the remote control is not to be used for a long time.
•Batteries contain chemical substances, they should be disposed of properly.
Risk of swallowing batteries!
•The product/remote control may contain a coin type battery, which can be swallowed.
•Keep the battery out of reach of children
at all times!
Class II equipment symbol:
This symbol indicates that this product has a double insulation system.
CLASS 1
LASER PRODUCT
Care for your product
•Do not insert any objects other than discs into the disc compartment.
•Do not insert warped or cracked discs into the disc compartment.
•Remove discs from the disc compartment if you are not using the product for an extended period of time.
•Only use microfiber cloth to clean the product.
EN 21
