4.6.Advanced Features
For some users enough is never enough. The DSATX has the ability to fine tune many of the parameters that control its behavior. By using Set and Get commands (‘S’ and ‘G’) it is possible to read and write these parameters to the DSATX. To use the Set command, type at the prompt, an ‘S’ followed by 2 numbers for the index, followed by either 4 numbers or 1 number for the value.
Ex:
>S011130 ß Set parameter 1 (LOWVOLTS) to 11.30V
To use the Get command type ‘G’ at the prompt followed by the 2 number index.
Ex:
>G90 ß Get parameter 90 (Program Memory Version) 0108 ß Returns this result (1.08)
4.7.Advanced Feature Tables
The following tables show the available Parameter settings and Queries. Parameters will respond to the Set and Get command. Queries will only respond to the Get command.
|
| Factory |
|
| Set By 'P' in |
Parameter |
| Default | Units | Description | Extended |
Index | Value | Basic Mode | |||
|
|
|
|
|
|
LOWVOLTS | 01 | 1100 | 10mV | Hard Coded Vin Low Battery Threshold (if USEPOTS =0) | Y |
VINHIGHTHRESH | 02 | 1300 | 10mV | Alternator "Turn on" Voltage Threshold |
|
HIGHVOLTS | 03 | 1650 | 10mV | Vin Over Voltage Threshold |
|
VOLTSHYST | 04 | 0045 | 10mV | Vin Voltage Hysteresis (Engine Cranking) |
|
VOLTSTHYST | 05 | 1000 | 10ms | Vin Voltage High to Low Time Window (Engine Cranking) |
|
VOLTSTHYST1 | 06 | 0100 | 10ms | Vin Voltage Low to High Time Window |
|
TURNONDELAY | 07 | 0100 | 10ms | Time To Wait After ACC High before sending turn on pulse |
|
PULSEWIDTH | 08 | 0100 | 10ms | Motherboard Power Switch Press Duration |
|
MAXTIMER1 | 09 | 1200 | 1s | Maximum CountDown Time set by Potentiometer P1 | Y |
TIMER1EE | 10 | 1200 | 1s | Hard Coded CountDown Time (if USEPOTS =0) | Y |
TIMETOKILL | 11 | 0090 | 1s | Time Allowed for Computer to Shut Down |
|
USEPOTS | 12 | 1 | 1=yes, 0=no | If set, P1 and P2 set CountDown Time and Vin Low Battery Threshold | Y |
ENABLESLEEP | 13 | 1 | 1=yes, 0=no | If set, Unit Will go use Sleep Mode, ACC High for Wake Up |
|
FEEDON | 14 | 1 | 1=yes, 0=no | If set, Serial Port Diagnostic Status Feed is Enabled |
|
VTURNON | 15 | 0 | 1=yes, 0=no | If set, Mb Switch Press occurs after Vin is above VINHIGHTHRESH | Y |
ACCTIMEVAL | 16 | 0050 | 10ms | Settling time for the ACC input (Debouncing time) |
|
TEMPHIGH | 17 | 0550 | 0.1 deg C | Maximum Operating Temperature |
|
TEMPLOW | 18 | 0100 | 0.1 deg C | Minimum Operating Temperature (Can be Positive or Negative) |
|
TEMPHYST | 19 | 0050 | 0.1 deg C | Temperature Stabilization Margin (Hysteresis to Prevent Oscillations) |
|
TEMPLOWSIGN | 20 | 0 | 1=pos, 0=neg | Polarity of TEMPLOW (Minimum Operating Temperature) |
|
TEMPTHYST | 21 | 0200 | 10ms | Temperature Time Stabilization Window (Temp must stay good/bad) |
|
ENABLE5VSBOFF | 22 | 1 | 1=yes, 0=no | Allows +5VSB Rail to Turn Off to Save Battery Life |
|
ENABLESHUTDOWN | 23 | 1 | 1=yes, 0=no | Allows unit to Send the Motherboard Switch Press for Shutdown |
|
MASTERMODE | 24 | 0 | 1=yes, 0=no | Allows DSATX to be cascaded with 2 or more DSATX for more Power |
|
EARLYAUXCUT | 25 | 0 | 1=yes, 0=no | AUX will go away as soon as shutdown pulse is sent |
|
Query
Index
Units
Discription
PlusVIN | 40 | N/A | 10mV | The Current Voltage at the VIN terminal |
Plus12 | 41 | N/A | 10mV | The Current Voltage on the 5V Rail |
Plus5 | 42 | N/A | 10mV | The Current Voltage on the 12V Rail |
Plus3_3 | 43 | N/A | 10mV | The Current Voltage on the 3.3V Rail |
ActualTemp | 44 | N/A | 0.1 deg C | The Current Temperature |
TempSign | 45 | N/A | 1=pos, 0=neg | The Current Temperature Polarity |
|
|
|
| Current VIN Low Voltage Threshold (hardcoded or set by P2 between |
LowVoltThresh | 46 | N/A | 10mV | volts) |
|
|
|
| Current CountDown Timer Value (hardcoded or set by P1 between 0 and |
CountDownTimerVal | 47 | N/A | 1s | MAXTIMER1) |
|
|
|
| Current State: 0 = Wakeup, 1 = Startup, 2 = Running, 3 = Count Down, 4 Shut |
CurrentState | 48 | N/A | N/A | Down, 5 Sleep, 6 Bad Temp |
MainCounter | 49 | N/A | 1s | Current Value of Counter used when Counting Down to Swtich States |
P_VERSION | 90 | N/A | N/A | Flash Memory Version Number |
E_VERSION | 91 | N/A | N/A | EEPROM Memory Version Number |
DSATX Manual | Copyright 2006 Mpegbox.com | Page 10 of 13 |
