Prepare the remote control
Caution
•• Risk of explosion! Keep batteries away from heat, sunshine, or fire. Never discard batteries in fire.
To insert the remote control battery:
1Open the battery compartment.
2Insert 2 AAA batteries with correct polarity
3Close the battery compartment.
a
b
c
Note
•• If you are not going to use the remote control for a long time, remove the batteries.
•• Do not use old and new or different types of batteries in combination.
•• Batteries contain chemical substances, so they should be disposed of properly.
Set clock
Note
•• You can set the clock in the standby mode only.
1In standby mode, press and hold PROG/ CLOCK SET to activate the clock setting mode.
»»SET CLOCK is displayed.
»»The 12 hour or 24 hour format is displayed.
2Press / to select 12 hour or 24 hour format.
3Press PROG/CLOCK SET.
»»The hour digits begin to blink.
4Press / to set the hour.
5Press PROG/CLOCK SET.
»»The minute digits begin to blink.
6Press / to set the minute.
7Press PROG/CLOCK SET to confirm.
Turn on
1Press .
»»The unit switches to the last selected source.
Switch to standby
1Press to switch the system to standby mode.
»»The backlight on the display panel is reduced.
»»The clock (if set) is displayed on the display panel.
To switch the system to Eco Power standby mode:
1 In standby mode, press and hold for more than 2 seconds.
»»ECO POWER is displayed.
»»The backlight on the display panel turns off.
EN 9