3.1.2 Connect your HiFi appliance

Depending on your HiFi /Audio receiver
equipment, you might have several options
to connect your digital receiver.
• Analogue connection
Connect the L/R audio output sockets to
the relevant L/R audio input sockets of your
audio equipment by means of a double
CINCH cable (not supplied). Consult the
user manual of your HiFi/Audio receiver
equipment to choose the proper analogue
audio inputs.
Note: With this connection set up you can
control the audio volume up/down and mute
with the remote control of your digital receiver
and alternatively with your HiFi's remote control.
• Digital connection
Connect the audio "DIGITAL OUTPUT"
socket to the relevant digital audio input
socket of your audio equipment by means
of an appropriate connection (not supplied).
Consult the user manual of your HiFi/Audio
receiver equipment to choose the proper
digital audio input.
Note: With this connection set up you can only
control the audio volume Up/Down and mute
with your Hifi /audio receiver remote control,
refer to its User Manual.

3.1.3 Connect your receiver to the

telephone line

Connect the Telephone Line socket to the
wall telephone outlet by means of the
supplied telephone cord and appropriate
adapter (adapter not supplied).
Note: The equipment has been approved
pursuant to Commission Decision 99/303/EC for
pan-European connection to the public switched
telephone network (PSTN). However, due to
differences between the individual PSTNs
provided for in different countries, the approval
does not, of itself, give an unconditional
assurance of successful operation on every PSTN
network termination point.
In the event of problems, you should contact
your equipment supplier in the first instance.
3.2 Receiver installation
1Switch on the TV set and select a channel.
2Plug the Receiver's power supply cord to
the mains. The receiver front panel LED
gets on, then the display.
3Now you should see the Welcomescreen
on your TV screen. After a few seconds,
the Welcome screen disappears.
4Then, a screen appears that allows you to
select the language. Highlight the desired
language by pressing W/Vand then press
OK.
You are prompted to confirm your choice
by pressing OK again.
5Next, highlight the country where you
operate the receiver by pressing W/Vand
then press OK.
You are prompted to confirm your choice
by pressing OK again.
6A screen appears that allows you to select
the TV screen format corresponding to
your TV set. Highlight the appropriate
format by pressing W/V. Press OK to
initiate the channel search.
Search operation is indicated by segments
moving around the display.
7Once it has been completed, follow the
prompts displayed on the screen.
Press OK to store any found channels and
tune the box to the first found TV channel.
Now you are ready to enjoy viewing your
terrestrial receiver. Refer to chapter 4 Day
to Day operation to learn more about using
your receiver.
Note : If any of the WELCOME, Language
selection or Country selection screen is not
displayed, press two times the TV/STB button to
get the screen displayed.
English
CONNECTION AND INSTALLATION 13
6610_A5_GB.qxd 01/09/2004 12:58 Page 13