[ Speaker Setup ]
When you connect a speaker system, you can optimize surround output for the connected speakers.
•[ Front Speaker ]
Option | Description |
[ Large ] | Produce low frequency |
| signal below 120 Hz. |
[ Small ] | Cannot produce low |
| frequency signal below |
120Hz.
•[ Center Speaker ] / [ Rear Speakers ]
Option | Description |
[ Large ] | Produce low frequency |
| signal below 120 Hz. |
|
|
[ Small ] | Cannot produce low |
| frequency signal below |
| 120 Hz. |
|
|
[ Off ] | No speaker is connected. |
|
|
•[ Subwoofer ]
Option | Description |
[ On ] | A subwoofer is |
| connected. |
[ Off ] | No subwoofer is |
| connected. |
•[ Speakers Volume ] – Set the volume level of each speaker to get the ideal audio balance.
1.Press OK.
2.Select a speaker, then press b B to adjust the volume.
3.Press OK to confirm and exit.
•[ Speakers Delay ] – Set the delay time for the center, subwoofer and rear speakers if they are placed closer to the listening position, so that the sound output from all speakers reach the listening position at the same time.
1.Press OK.
2.Select a speaker, then press b B to set the delay time.
3.Press OK to confirm and exit.
Note
•[ Speaker Setup ] setting is only available if you have set the [ Analog Output ] setting to [ Multi Channel ].
[ CD Upsampling ]
For better sound quality in stereo mode, convert the music CD to a higher sampling rate.
•[ Off ] – turn off
•[ 88.2kHz ] – convert to twice the original sampling rate.
•[ 176.4kHz ] – convert to four times the original sampling rate.
[ Night Mode ]
You can play DVDs with Dolby Digital mode at a low volume, without disturbing others. High volume output is decreased and low volume output is increased to an audible level.
•[ On ] – turn on night mode.
•[ Off ] – enjoy surround sound with its full dynamic range.
30EN
