Operating the System
Notes:
–PLUG and PLAY will be reinitiated again during the next power up if :
i)PLUG and PLAY installation was not completed.
ii)No stereo frequency being detected during PLUG and PLAY, "CHECK ANTENNA" will be displayed.
–You can store any radio stations manually or automatically after PLUG and PLAY.
–When PLUG and PLAY is used, all previously stored radio stations will be replaced.
–During PLUG and PLAY, if no button is pressed within 15 seconds, the system will go to demonstration mode (if demonstration mode is enable)
Demonstration mode
The system has a demonstration mode that shows the various features offered by the system.
To disable the demonstration mode
●Press and hold Ç (on the system only) for 5 seconds when the system is in demonstration mode.
➜"DEMO OFF" is displayed.
➜The system will switch to standby mode.
To enable the demonstration mode
●Press and hold Ç (on the system only) for 5 seconds when the system is in standby mode. ➜ The demonstration will begin.
Notes:
–If the demonstration mode has not been disabled, it will resume 5 seconds later after the system switches to standby mode.
–When the system is switched on from the main power outlet, the CD changer tray may open and close again to initialize the set.
–Even though the AC power cord is removed from and reconnected to the wall socket, the demonstration will remain off until it is switched on again.
Switching the system ON
¶Press CD, TUNER, TAPE or AUX.
You can also switch on the system by pressing any one of the CD DIRECT PLAY buttons.
Switching the system to standby mode
¶Press
➜ The system will switch to standby mode.
Switching the system to ECO POWER standby mode (when Demonstration mode is stopped)
¶Press ECO POWER or press and hold B on the remote control for more than 2 seconds to switch to eco power standby mode (< 2 watts).
➜"ECO PWR" will be displayed, after which the display screen goes blank.
➜The ECO POWER LED will be lit.
To switch on the system from ECO POWER mode
¶Press ECO POWER.
➜The system will switch to last selected source.
¶Press CD, TUNER, TAPE or AUX on the remote control
➜The system will switch to the selected source.
Note:
–If the demonstration mode has not been disabled, it will resume 5 seconds later.
English
|
| 13 |
pg | 13 | 12/7/00, 3:42 PM 3139 115 20641 |
