Recording
CD Synchro Start Recording
1Load a blank tape into tape deck 2 and a disc into a disc tray.
2Press CD to select CD mode.
¶You can program the tracks in the order you want them to be recorded (see Programming Tracks). If not, select the disc by pressing CD (CD 1•2•3) and the tracks are recorded according to the order on the selected disc.
3Press RECORD to start recording.
➜ The REC starts flashing.
¶Disc will start playback automatically.
4Press Ç to stop recording.
Dubbing tapes deck 2)
1Press TAPE ( TAPE 1•2 ) to select tape deck 2.
2Load the prerecorded tape into tape deck 1 and a blank tape into tape deck 2 with full spool to the left.
3Press DUBBING.
➜"DUB" with "2" scrolling right will be displayed. ¶ Dubbing will start immediately.
➜The REC starts flashing.
4Press Ç to stop dubbing.
Notes:
– At the end of side A, flip the tapes to side B and repeat the procedure.
– Dubbing of tapes is only possible from tape deck 1 to tape deck 2.
– To ensure good dubbing, use tapes of the same length.
– You can switch to other source while dubbing.
Recording from other sources
(only on tape deck 2)
1Load a blank tape into tape deck 2 with the open side downward.
2Press CD, TUNER or AUX.
¶Start playback of the selected source.
3 Press RECORD to start recording.
➜The REC starts flashing.
4Press Ç to stop recording.
Notes:
– During recording, it is not possible to listen to another source.
Digital Recording via Digital Out
For CD digital recording, please refer to the Instructions Manual of the CD Recorder, digital audio equipment, etc.
English
|
| 25 |
pg | 25 | 12/7/00, 3:43 PM 3139 115 20641 |
