Philips FW-V320/21 General Information, Environmental Information, Supplied Accessories, English

General Information

IMPORTANT:

PLEASE NOTE THAT THE VOLTAGE SELECTOR LOCATED AT THE REAR OF THIS SYSTEM IS PRESET AT 220V FROM THE FACTORY.

FOR COUNTRIES THAT OPERATE AT 110-127V, PLEASE ADJUST TO 110-127V

BEFORE YOU SWITCH ON THE SYSTEM.

¶The type plate (which contains the serial number) is located at the rear of the player.

¶Recording is permissible if copyright or other rights of third parties are not infringed.

Environmental Information

All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet).

Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.

Supplied Accessories

–Remote control

–Batteries (two AA size) for remote control

–AM loop antenna

–FM wire antenna

–AC power cord

–One Video cinch cable

Safety Information

¶Before operating the player, check that the operating voltage indicated on the typeplate (or the voltage indication beside the voltage selector) of your player is identical with the voltage of your local power supply. If not, please consult your dealer.The typeplate is located at the rear of your player.

¶When the player is switched on, do not move it around.

¶Place the player on a solid base (e.g. a cabinet).

¶Place the player in a location with adequate ventilation to prevent internal heat build-up in your player. Allow at least 10 cm (4 inches) clearance from the rear and the top of the unit and 5 cm (2 inches) from the each side.

¶Do not expose the player to excessive moisture, rain, sand or heat sources.

¶Under no circumstances should you repair the player yourself, as this will invalidate the warranty!

¶If the player is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens of the disc unit inside the player. Should this occur, the CD player will not operate normally. Leave the power on for about one hour with no disc in the player until normal playback is possible.

¶Electrostatic discharge may cause unexpected problems. See whether these problems disappear if you unplug the AC power cord and plug it in again after a few seconds.

¶To disconnect the player from the power supply completely, remove the AC power plug from the wall socket.

English

		7
pg 01-32/V320/21-Eng	7	3139 115 20852
		28/05/2001, 09:02 AM