Basic Functions
English |
IMPORTANT!
Before operating the system, complete the preparation procedures.
Plug and Play
Plug and Play allows you to store all available radio stations automatically.
First time setup/power up
1When you turn on the main supply, "AUTO INSTALL - PRESS PLAY" is displayed.
2PressÉÅ on the system to start installation.
➜"INSTALL" is displayed, followed by "TUNER" and "AUTO".
➜PROG starts flashing.
➜All available radio stations with sufficient signal strength will be stored automatically, starting from FM and followed by MW band.
➜When all the available radio stations are stored or the memory for 40 presets are used, the last preset radio station will be played.
To exit without storing the Plug and Play
●Press Çon the system.
➜ If you do not complete the Plug and Play installation, the function will be restarted when you next turn on the main supply again.
Notes:
–When the power is turned on, the disc tray may open and close to initialise the system.
–If no stereo frequency is detected during Plug and Play, "CHECK ANTENNA" will be displayed.
–During Plug and Play, if no button is pressed within 15 seconds, the system will exit Plug and Play mode.
To reinstall Plug and Play
1In standby or demonstration mode, press and holdÉÅon the system until "AUTO INSTALL - PRESS PLAY" is displayed.
2PressÉÅagain to start installation.
➜ All previously stored radio stations will be replaced.
13
