Tape Operation/Recording
E n g l i s h
To rewind or fast forward during playback
●Press and hold à or á until the desired passage is reached, then release.
➜The tape continues playing.
●The tape will stop automatically at the end of the tape during rewinding or fast forwarding.
➜During searching, the sound is reduced to a low volume.
To rewind or fast forward when playback is stopped
1Press à or á.
2Press Ç when you reached the desired passage.
To reset tape counter number
●When in stop mode, pressÇ.
➜ “TP1 000” or “TP2 000” will be displayed.
Notes:
–During rewinding or fast forwarding of a tape, it is also possible to select another source (CD, TUNER or AUX, for example).
–The tape counter will automatically set to zero after detecting end of tape.
General Information on
Recording
●For recording, use only tape of IEC type I (normal tape) or IEC type II (Cr02).
●The recording level is set automatically, regardless of the position of the Volume,VAC, DSC and so forth.
●The tape is secured at both ends with leader tape. At the beginning and end of the tape, nothing will be recorded for six to seven seconds.
●To prevent accidental recording, break out the tab on the left shoulder of the tape side you want to protect.
●If “CHECK TAPE” is displayed, the protection tab has been broken. Put a piece of clear adhesive tape over the opening. Do not cover
the Cr02 tape detection hole when covering the tab opening.
IMPORTANT!
–Recording is permissible if copyright or other rights of third parties are not infringed upon.
–Recording is possible only on tape deck 2.
–Switch off Dolby Pro Logic when recording.
Preparation for Recording
1Press TAPE (TAPE 1•2) to select TAPE 2.
2Load a recordable tape into tape deck 2 with full spool to the left.
3Prepare the source to be recorded. CD – load the disc(s).
TUNER – tune to the desired radio station. TAPE – load the prerecorded tape into tape deck 1 with the full spool to the left.
AUX – connect external equipment.
When recording is in progress
➜ starts flashing.
●It is not possible to listen to another sources except when dubbing tapes.
●It is not possible to activate the timer function.
One Touch Recording
1Press CD, TUNER or AUX to select the source.
2Start playback of the selected source.
3Press REC to start recording.
To stop recording
●Press Ç on the system.
Note:
– One Touch Recording is not possible in TAPE mode, "SELECT SOURCE" will be displayed.
24
pg | 24 | 3/7/01, 4:12 PM | 3139 115 20621 |