Clock/Timer
2Press CD, TUNER or TAPE to select the desired source.
●Before setting the timer, make sure the music source has been prepared.
CD – Load the disc(s).To start from a specific track, make a program (refer to “CD Operation - Programming the disc tracks”).
TUNER – tune to the desired radio station. TAPE – load the prerecorded tape into tape
deck 2.
3Press à or á on the system repeatedly to set the hour for the timer to start.
4Press í or ë on the system repeatedly to set the minute for the timer to start.
5Press CLOCK•TIMER to store the start time.
➜"TIMER ON" will be displayed and followed by the set timer "XX:XX" and then the selected source.
➜TIMER 
will remain on the display.
●At the preset time, the selected source will play.
To exit without storing the setting
●Press Çon the system.
Notes:
–If CD is the selected source and it is not available when the preset time is reached,Tuner will be selected automatically.
–During timer setting, if no button is pressed within 90 seconds, the system will exit timer setting mode automatically.
To deactivate the TIMER
●Press TIMER ON/OFF on the remote control. ➜ The display will show "CANCEL" and TIMER 
will disappear from the display.
Sleep Timer Setting
The sleep timer enables the system to switch to Standby mode automatically within a preset amount of time.
1Press SLEEP on the remote control repeatedly to select a preset time.
➜The selections are as follows (time in minutes):
15 ™ 30 ™ 45 ™ 60 ™ OFF ™ 15 …
➜"SLEEP XX" or "OFF" will be displayed. "XX" is the time in minutes.
2When you reach the desired length of time, stop pressing the SLEEP button.
➜SLEEP will appear on the display, except for
"OFF" mode.
➜The Sleep Timer is now set. Before the system switches to standby mode, a countdown of 10 seconds will be displayed.
"SLEEP 10" ™ "SLEEP 9".... ™ "SLEEP 1"
™"SLEEP"
While SLEEP mode is activated
To check the remaining length of time
●Press SLEEP once.
To change the preset sleep timer
●Press SLEEP twice.
➜ The display will show the remaining time followed by the sequence of sleep timer options.
To deactivate the Sleep Timer
●Press SLEEP repeatedly until "OFF" is displayed, or press the STANDBY ON button.
E n g l i s h
To activate the TIMER
●Press TIMER ON/OFF on the remote control. ➜ The last set timer information will be shown for a few seconds and TIMER 
will appear on the display.
27
pg | 27 | 3/7/01, 4:12 PM | 3139 115 20621 |
