Radio Reception
Note:
–If no preset number is selected, automatic preset will begin from preset (1) and all your former presets will be overridden.
Manual Preset Programming
1Tune to your desired radio station (refer to ÒTuning to radio stationsÓ).
2Press PROG.
➜PROG starts flashing.
➜The next available preset number is displayed for selection.
To store the radio station to another preset number
●Press í or ë to select the desired preset number.
3Press PROG again to store the radio station. ➜ PROG disappears.
●Repeat steps
To exit manual preset mode
●Press Ç on the system.
Notes:
–If you attempt to store more than 40 preset radio stations, "FULL" is displayed.
–During programming, if no key is pressed within 20 seconds, the system will exit the programme mode automatically.
Erasing a preset radio station
1Press í or ë to select the preset radio station to be erased.
2Press and hold Çon the system until ÒPRESET DELETEDÓ is displayed.
➜The deleted radio frequency remains on the display.
➜The preset numbers of all other preset radio stations in the band with higher numbers are also decreased by one.
●Repeat steps
Changing tuning grid (not available for
all versions)
In North and South America, the frequency step between adjacent channels in the MW band is 10 kHz (9 kHz in some areas). The preset frequency step in the factory is 9 kHz.
Changing the tuning grid will erase all previously stored preset radio stations.
1Disconnect the system from the AC power supply (pull out the AC power cord).
2While holding down TUNER and á on the system, reconnect the system to the AC power supply.
➜The display will show "GRID 9" or "GRID 10".
E n g l i s h
Tuning to preset radio stations
●Once youÕve programmed the radio stations, press í or ë to select the desired preset
number.
➜ The preset number, radio frequency, and waveband are displayed.
Notes:
–GRID 9 and GRID 10 indicate that the tuning grid is in step of 9 kHz and 10 kHz respectively.
–The FM tuning grid also will be changed from 50 kHz to 100 kHz or vice versa.
For Recording, please refer to “Tape Operation/Recording”.
25
