Philips GC4320, GC4330, gc4310, GC4340 manual Min

		ENGLISH 11
Problem	Possible cause(s)	Solution
The iron is plugged in but the soleplate	There is a connection problem.	Check the mains cord, the plug and
is cold.		the wall socket.
	The temperature dial has been set to	Set the temperature dial to the
	MIN.	required position.
No steam.	There is not enough water in the	Fill the water tank (see chapter
	water tank.	'Preparing for use').
	The steam control has been set to	Set the steam control to a position
	position O.	between 1 and 6 (see chapter 'Using
		the appliance').

The iron is not hot enough and/or the drip-stop function has been activated.

Select an ironing temperature that is suitable for steam ironing (2 to MAX). Put the iron on its heel and wait until the amber pilot light has gone out before you start ironing.

No shot of steam or no vertical shot of	The (vertical) shot-of-steam function	Continue ironing in horizontal position
steam.	has been used too often within a very	and wait a while before using the
	short period.	(vertical) shot-of-steam function again.

The iron is not hot enough.

Select an ironing temperature that is suitable for steam ironing (2 to MAX). Put the iron on its heel and wait until the amber pilot light has gone out before you start ironing.

Water droplets drip onto the fabric.	The cap of the filling opening has not	Press the filling cap until you hear a
	been closed properly.	click.
	An additive has been poured into the	Rinse the water tank and do not put
	water tank.	any additive in the water tank.
Flakes and impurities come out of the	Hard water forms flakes inside the	Use the calc-clean function a few
soleplate during ironing.	soleplate.	times (see chapter 'Cleaning and
		maintenance').

The red pilot light blinks (type GC4320 only).

The safety shut-off function has switched the iron off (see chapter 'Features').

Move the iron slightly to deactivate the safety shut-off function.The pilot light goes out.

The blue alert light blinks (types	The safety shut-off function has	Move the iron slightly to deactivate
GC4340 and GC4330 only).	switched the iron off (see chapter	the safety shut-off function.The blue
	'Features').	alert light stops blinking.

The iron is plugged in but the blue alert There is a connection problem. light is out (types GC4340 and

GC4330 only).

Check the mains cord, the plug and the wall socket.