Connect and Charge

1.Connect the supplied multi-voltage adaptor/charger to your player by plugging it into the DC-In connector at the bottom of the player and then plug the other end into a standard AC outlet.

2.The battery will be fully charged in 4 hours when charging it for the first time and 70% charged in 1 hour for quick charge.

3.The player is fully charged when the charging animation stops and is displayed.

Battery level indication

The approximate power levels of your battery are indicated as follows:

Battery is full

Battery is two-thirds full

Battery is half full

Battery is low

Battery is empty

When the battery is nearly empty, the following power low warning screen will blink and emit a beep tone. When you hear a double beep, your player will power down in less than 60 seconds. All settings and un- finished recordings will be saved before the player shuts down.

Install

1.Insert the CD supplied with your product into the CD ROM drive of your PC.

2.Follow the onscreen instructions to complete the installation of Windows Media Player (including necessary plug-ins) and Philips Device Manager.

IMPORTANT!

For US: There are two CDs and both are required for installation.

3.You may need to restart your PC after software installation.

4.If the installation program does not start automatically, browse the CD contents via Windows Explorer and run the program by double clicking on the file ending with .exe.

4

Page 8
Image 8
Philips HDD6320 user manual Connect and Charge, Install, Battery level indication