Troubleshooting
Problem | Solution |
|
|
l i s h
The DVD player does not start playback.
There is no sound from the center and rear speakers.
Radio reception is poor.
The remote control does not function properly.
Progressive Scan.
–Insert a readable disc with the playback side facing down. The
–Check the disc type, color system and region code.
–Check for any scratches or smudges on the disc.
–Press SYSTEM SETUP to turn off the setup menu screen.
–You may need to enter the password in order to change the parental control rating level or to unlock the disc for playback.
–Moisture has condensed inside the system. Remove the disc and leave the system turned on for about an hour.
–Press CENTER +- or REAR +- to adjust the volume level.
–Make sure the center and rear speakers are connected correctly.
–Press SURROUND button to select a correct surround sound setting.
–Make sure the source you are playing is recorded or broadcast in surround sound (DPL II, Dolby Digital, etc.)
–If the signal is too weak, adjust the antenna or connect an external antenna for better reception.
–Increase the distance between the system and your TV or VCR.
–Tune in to the correct frequency.
–Place the antenna farther away from any equipment that may be causing the noise.
–Select the source (DISC or TUNER, for
example) before pressing the function button (ÉÅ, S, T.)
–Reduce the distance between the remote control and the system.
–Replace the batteries with new ones.
–Point the remote control directly toward the IR sensor.
–Check that the batteries are loaded correctly.
–If the progressive function is activated but your TV does not support progressive scan or the cables are not connected accordingly, the TV screen will be blank.You can deactivate progressive scan as below.
1)Press STANDBY ON on the front panel to switch on the DVD system.
2)Press OPEN/CLOSE 0 on the front panel, while pressing down OPEN/CLOSE 0, press numerical key pad “1” on the remote control.
The blue Philips DVD background appears on the TV screen.
E n g
37
